Similar issue: If I have a needle display type gauge for Engine RPM and set Minimum = 0, Maximum = 7000, the needle does not move above 0.

I synced the videos in iMovie. I just looked for a peak in the audio track on the Track Recorder video and then noted how far in from the beginning it...

You can use the GoPro or any other video source if you can get Track Recorder to work. You need to record with both Track Recorder and the GoPro, then...

I believe that Torque will hang unless you add a "NO DATA" response to every PID request that you are not replying to with sensor data. For example, i...

30 PIDs / second should be no problem. If you are only getting 1 PID / second, there is probably an expected response timing out. Can you log the seri...

The latest update seems to have resolved this issue.

^^^That post on emulating an adapter is great! That is really all you need to do. Not sure if Torque can read data from multiple sources at once....

I am actually working on this same thing. Have it going ok with a variety of gauge senders and it is pretty interesting to use as a data logger or jus...

I believe Torque will do the unit conversion for you, so your formula does not need to include it. Use the Celsius formula, specify that it is in degr...

Seems crazy, but oil pressure is not one of the standard OBD-II PIDs. It's not just Ford.

Reading up on this some more, I think you're right. The adaptive timing is just a way to eliminate the lag caused by the timeout delay that would norm...

I found in the ELM327 datasheet section about adaptive timing: The number of responses that you provide can be any single hex digit, of value 0 to ...

Sounds like you are making good progress! Most of the PID formulas are available here:

I don't believe it is the number of failed attempts to connect to the ECU, as that is indicated by the number of "errors". The "other faults" count se...

Wayne, just out of curiosity, how many PIDs per second does Torque receive from the Orion BMS?

There is an example of the ATPC command / reply in the ELM327 datasheet but it's in the description of the AT PB command. Just sending an 'OK' should ...