In the manage PIDs list, there is one for EBP, Exhaust Back Pressure. I do not remember if it was working before. I'll see if it works in the next ...

Here is the one for my 6.0L I see it is reading the same PID. I am putting in a space between each character for easier reading in the equatio...

Quote from kmacicek on October 8, 2012 so was just wondering, is there a pid for ebp, if so can you post the formula for this so that i can input it ...

Quote from ncstan on September 12, 2012 Thanks amdriven2liv for the link. U2013 - Network When I open the fault code it just says Null ___...

I have not had that come up when I have scanned for codes. I'll see if I can find that code somewhere. Only suggestion I would have is to make ...

Quote from Ironlion on August 27, 2012 I used ((((A*256)+B)/100)+40)*(9/5)+32 Tried it again yesterday with a cold engine as a baseline. ECT: 91....

ironlion, When I want to "Add a Display" it takes me to which gauge I want, Then it takes me to the list of pid's to choose from. In that...

Quote from Ironlion on September 8, 2012 Since it does not come up in the raw data list, what should I look for next? Not sure what else to say. I...

Scott, Here is a post on another forum. If it is hard to read, I will post another link that shows a post I did adding values to Scangauge II gauge...

There are 2 Engine oil gauges in the list, make sure you are setting the right one up. For us, it's name is "ENGINE OIL TEMP". Not, "ENGINE OIL TEMPER...

Make sure you have the correct amount of " ( " in each segment. ( ( ( ( A * 2 5 6 ) + B ) / 100 ) - 40 ) * ( 9 / 5 ) + 32 I put a space in bet...

I have had great success with the PLX. No complaints from me.

Took some doing, but got it. Now, just need to remember what I did!!! LOL

Yes, I figured I had lost track of where I saw it. Now, I do not see TCM. (transmission) Any chance it is somewhere else?

Quote from admin on May 27, 2012 Hi Don't really know too much about the scangauge files, but the data that the example ends up with (going into T...

Quote from PORKWALL on May 24, 2012 I have a question about the EOT it always reads 32 degrees F. I know this is wrong. What can I do? Which equ...

Quote from nc4wd on April 15, 2012 You have designed a FANTASTIC app. I recently switched to an iPhone and iPad (because of work) and I miss my torqu...