Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.




Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Problem receiveng data

Pages: [1]
Author Topic: Problem receiveng data
John M
Member
Posts: 4
Post Problem receiveng data
on: February 19, 2018 (GMT)

Hi everyone,sorry for my bad english but I write from Italy,and i don’t speak well english.
I have got a Subaru WRX STi MY 05 EDM and I use the Plx Kiwi 3 for read the ecu data with Torque. The problem is that my mechanic has remapped the ecu with ecuflash software,replacing the ecu firmware for installing dual map and now Torque does not receive ecu data although is correctly connected(app says connected with the ECU). All dials say “no data”…
Is there a solution for that?
Thanks very much at everyone.

moreause
Member
Posts: 448
Post Re: Problem receiveng data
on: February 22, 2018 (GMT)

i would says check in the old message

i have seen this in the pass… but don’t know if they found a solution

my personnal guess …i would say no

cintakc
Member
Posts: 1387
Post Re: Problem receiveng data
on: February 23, 2018 (GMT)

John M
If you have a Torque application that shows that there is a connection to the ECU, go to the adapter status tab and look at the bottom of the Available sensors, take a screenshot and put it here
in the settings of the phone – the mode for the developer put the birdie Bluetooth HCI snoop log, in the phone log exchange for bluetooth for the program with the engine ECU, will be called btsnoop_hci.log
give a link to this log here

Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.068 seconds.

  Follow me on twitter