Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Can't Reset Fault

Pages: [1]
Author Topic: Can't Reset Fault
John949
Member
Posts: 2
Post Can't Reset Fault
on: May 6, 2017 (GMT)

I’ve been using Torque with a bluetooth adaptor successfully for several years on a number of different cars but when I tried it on a friend’s Rover 75 it wouldn’t clear a “general misfire” code. Has anyone else come across similar problems? Am I doing something wrong or have Rover “bent” the OBDII rules so that only their test kit can clear faults?
John949
Member
Posts: 2
Post Re: Can
on: May 7, 2017 (GMT)

Tried again today and Torque showed no faults despite the ‘check engine’ light being on. Clearing the faults had no effect.

Tried using VCDS in OBDII mode and it showed P0300, which is a generic misfire code that Torque should be able to read and identify as it is in the OBDII standard set. It also showed a pending P1319, which is a Rover specific one.

Not entirely sure whether I eventually managed to clear them with VCDS or they just reset because I fixed the misfire. Anyway the light is out so onward and upward.
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.048 seconds.

  Follow me on twitter