Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Stalls below 60 degress

Pages: [1]
Author Topic: Stalls below 60 degress
j5hertzler
Member
Posts: 4
Post Stalls below 60 degress
on: October 16, 2016 (GMT)

I have a 2005 Mustang V6. When the temperature falls below 60 degrees the car will start, rev to 1300rpm and then after one minute die. If it is nice outside, there is no problem. I had it at the shop and they think it’s the Engine Control Module which they cannot replace. I would like to try other things. I did replace the fuel filter. There are NO error codes. My question:

Can I install a PID or read sensor data that would help me pinpoint the cause?
MPD56
Member
Posts: 276
Post Re: Stalls below 60 degress
on: October 16, 2016 (GMT)

Might have to bring it to the dealer to read the Ford Specific codes?

Temperature sensitive problem, could be caused by the MAP or MAF sensor. Closed or open loop ECM control.
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.009 seconds.

  Follow me on twitter