Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Track recoredr RPM gauge

Pages: [1]
Author Topic: Track recoredr RPM gauge
TadyTheFish
Member
Posts: 1
Post Track recoredr RPM gauge
on: September 3, 2016 (GMT)

Hello!

I have a question about the RPM gauge in Track recorder. The Gauge reads 7000 rpm maximum. How cn i change it to 15000?
i made a adapter that fakes a ELM327 device, so i can read OBD data from a Honda motorcycle and display it in Torque.

I made a profile and set it to 15000. The settings work in Torque but the gauge in Track recorder doesn’t change.

And i would like to know if there is a way for the MAP gauge to read only BAR and not Bar/mmHG?

Thank you!
MrMichael
Member
Posts: 3
Post Re: Track recoredr RPM gauge
on: September 26, 2016 (GMT)

2nd that, stuck at 7000rpm and need 9500rpm, also the throttle position show 80% at full, would prefer the graph throttle position to record and review our track runs. Gear estimation from RacingMeter and relative “G”.

Done quite a few recordings with track recorder this season!

Great work!
Capp777
Member
Posts: 2993
Post Re: Track recoredr RPM gauge
on: September 26, 2016 (GMT)

Question… can you side step this problem
with custom pids with the correct scaling?
Just curious. (I drive an OBDI Jeep and cannot
test until family visits).

Another Torque User.
Capp777
Member
Posts: 2993
Post Re: Track recoredr RPM gauge
on: September 27, 2016 (GMT)

Very interesting…

I tried to recreate your problem offline
and observed the same 7000 max.

I then created a custom pid with equation
Val{Engine RPM} with a max of 15000.

When I went back into Track Recorder I was
shocked to see the original rpm gauge had
updated to 15000.

Added the new custom pid which displayed
with a max of 15000.

Maybe you just need to leave Track Recorder
after adding gauge then reenter for it to update?

Subsequent attempts at changing back and forth
from 15000 and 7000 updated immediately in
Track Recorder.

Curious if you are seeing the same behavior.
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.018 seconds.

  Follow me on twitter