Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Duramax Lbz to lb7 problems

Pages: [1]
Author Topic: Duramax Lbz to lb7 problems
sledstorm1
Member
Posts: 5
Post Duramax Lbz to lb7 problems
on: October 7, 2013 (GMT)

I have an 07 chevy duramax lbz, I have never had issues connecting before always worked good. Today I used torque to check the balance rates on a friends Lb7 04 duramax. I had issues with connecting with his truck at first but then it connected. I was able to check his balance rates. Then I went back to my truck the 07 and my phone would not connect. I have not gotten it to reconnect to my truck yet. And when I went back to the 04 the balance rates did not work right. I know there are protocol differences between the to trucks but I have never had this issue before. Does anyone have any thoughts,

Capp777
Member
Posts: 2993
Post Re: Duramax Lbz to lb7 problems
on: October 7, 2013 (GMT)

You should create a vehicle
profile for each truck and specify
the correct protocol to use in the
profile settings.
sledstorm1
Member
Posts: 5
Post Re: Duramax Lbz to lb7 problems
on: October 7, 2013 (GMT)

Does anyone know the correct protocal for both trucks. The 07 and 04.
Capp777
Member
Posts: 2993
Post Re: Duramax Lbz to lb7 problems
on: October 7, 2013 (GMT)

After you successfully connect to your
vehicle… look under adapter status to
determine the protocol in use.

Edit:

VPW or CANSF?
sledstorm1
Member
Posts: 5
Post Re: Duramax Lbz to lb7 problems
on: October 8, 2013 (GMT)

ok thank you
Dogface1SG
Member
Posts: 18
Post Re: Duramax Lbz to lb7 problems
on: November 15, 2016 (GMT)

did you get it to read balance rates on your 07 LBZ?
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.086 seconds.

  Follow me on twitter