I think you needed to record these 2 or 3 parameters in the log, save the log and then analyze it
it is possible only in the journal you will see short-term changes of individual PIDs

Quote from cintakc on April 6, 2018
I think you needed to record these 2 or 3 parameters in the log, save the log and then analyze it
it is possible only in the journal you will see short-term changes of individual PIDs

How do i do that?

I feel that i have not been able to answer before

I do not know what happened, but I’ve been a few days without being able to connect.

Well, the other day, the car made a regeneration and I was able to register it.

I registered the PID 2220F2 and the PID 223039

The regeneration began with 1135 km from the previous one.

At 56 seconds, it passed directly from stage 1 to stage 3 (there was no stage 2)

1 minute 13 seconds later change to stage 4 and it lasted 5 minutes 15 seconds

Stage 1 _ 17:08:36 _ 1135 Km

Stage 3 _ 17:09:32 _ 1135 Km

Stage 4 _ 17:10:45 _ 1135-1145 Km

End _ 17:16:00 _0 Km

perhaps it should be so, I do not know the algorithm of the particulate filter regeneration

Quote from cintakc on May 4, 2018
perhaps it should be so, I do not know the algorithm of the particulate filter regeneration

Thank you very much for your quick answer

Thnx cintakc.
I will send them to my friend and as soon as he answers I will post the results.

I’m sorry, I did not specify I need answers in hexadecimal form, they can be obtained in the PID test mode
you need to enter the PID editing mode and press the Test button

Hello again cintakc.
There u r :
PID Result

223273 62327300
223274 62327400
223275 6232754F
223276 62327600E164
223277 62327700023F
223278 6232780006C1
223279 62327984
22327a 62327A021D
223035 62303514
22303a 62303A0308
223047 6230470006

PIDs DPF for Astra-J 1.3 MY2012

"Name","ShortName","ModeAndPID","Equation","Min Value","Max Value","Units","Header"
"Astra-J DPF Differential Pressure Sensor","Diff.pres.sen","223035","A*5/255","0","5","V","7E0"
"Astra-J DPF Differential Pressure","Diff. press.","223273","A","0","255","kPa","7E0"
"Astra-J DPF Soot Accumulation","DPF Soot","223275","A","0","100","%","7E0"
"Astra-J Distance after last DPF replacement","Dis.last DPF repl","223276","A*65536+B*256+C","0","100000","km","7E0"
"Astra-J Distance Since Last DPF Regeneration","Dist.DPF reg","223277","A*65536+B*256+C","0","100000","km","7E0"
"Astra-J Regeneration state DPF","DPF state","223274","A*100/255","0","100","%","7E0"
"Astra-J Average DPF Inlet Temperature During Regeneration","DPF Inlet temp","223279","A*5-40","-40","1235","degree C","7E0"
"Astra-J Average duration of regeneration DPF","Aver.dur.DPF","22327A","A*256+B","0","65535","S","7E0"
"Astra-J Counter interrupted regenerations DPF","Coun.inter.DPF","223047","A*256+B","0","65535","counts","7E0"
"Astra-J Average distance Between DPF Regeneration","Av.dist.btwn DPF","223278","A*65536+B*256+C","0","100000","km","7E0"

it would be a good idea to compare the testimony with another program in order to clarify whether the formulas are written correctly or with the scanner readings

write about the results of the audit PIDs