I purchased Torque Pro a while ago but only recently had more time to have a play and set it up properly. Working quite well apart from all the gauges relating to accelerations amd decelerations. I.e. The 0-60mph, 1/4 mile, 60-0mph, etc. They all remain at zero as if no data has reached them.
I have tried in both of my cars with the same OBDII adaptor. I am assuming these gauges require speed from OBD. If so, the speed OBD gauge works fine. Is a certain data transfer, refresh rate needed before they will work, or is it some other problem? Thanks in advance for any hints.

Quote from moreause on April 23, 2020
last time i check you had to start from a stand still and you have to start the fonction

other wise it’s not working

but its been years since i tried it

Thanks, Moreause. Can you recall how they are started? I can’t see anything obvious. Is it to do with logging?

i went for i ride just to confirm

you need the gage to be on the active screen

if you are moving they will display X

when you stop they will show ready

when you start they change to ….

and finaly a value appear when the value is reach

ready come back when you stop again

Thanks for the answers. It worked. I tried it today with just one gauge for 0-60mph. My reader is extremely slow I think.