Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » is it possible set up initial screen?

Pages: [1]
Author Topic: is it possible set up initial screen?
calaverak
Member
Posts: 2
Post is it possible set up initial screen?
on: July 12, 2019 (GMT)

Hi mates,

I would like to know if it is possible to configure it.

In my version of Torque i can see it like so:

(sphere and options shifted to the right)

And I would like it was like so:

And one question more:
Is it possible to change the information of sphere?
Right now i only can see the acceleration, and i would like to see rpm… (in initial screen)

Thanks in advance.
moreause
Member
Posts: 632
Post Re: is it possible set up initial screen?
on: July 13, 2019 (GMT)

from what i remember no it’s not possible to customise it

RPM is the default value, it switch from acceleration to rpm when the car is connected
calaverak
Member
Posts: 2
Post Re: is it possible set up initial screen?
on: July 14, 2019 (GMT)

Ok, thanks a lot of your reply.

Then it only depends on the torque version right (old versions centered, modern versions all on the right)?

Regards
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.012 seconds.

  Follow me on twitter