Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.




Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Can-Bus Baud Rate?

Pages: [1]
Author Topic: Can-Bus Baud Rate?
Pedro123
Member
Posts: 14
Post Can-Bus Baud Rate?
on: February 23, 2019 (GMT)

Just setting up TorquePro and get to choose protocol.

Chooses are

ISO 15765-4 CAN (11 bit ID,500 Kbaud)
ISO 15765-4 CAN (29 bit ID,500 Kbaud)
ISO 15765-4 CAN (11 bit ID,250 Kbaud)
ISO 15765-4 CAN (29 bit ID,250 Kbaud)

The ISO 15765-4 is correct for my 2017 Sonata, but which baud rate do I choose – or does it matter?

Thanks

F-150Torqued
Member
Posts: 437
Post Re: Can-Bus Baud Rate?
on: February 24, 2019 (GMT)

Since the “USB INTERFACE” option DOES _NOT_ work with ANY usb interface I know of, you’re not going to get anywhere close to either of those using a Bluetooth interface.

Probably the auto selection is your best bet.

—————-

54371019

Pedro123
Member
Posts: 14
Post Re: Can-Bus Baud Rate?
on: February 24, 2019 (GMT)

Yes thanks, I just selected “Auto” as the selection.

Capp777
Member
Posts: 2978
Post Re: Can-Bus Baud Rate?
on: February 24, 2019 (GMT)

After Torque connects you should be able
to see what protocol is used under Adaptor
Status icon information.

The baud rates you listed are on the vehicle’s
network. The RS232 side of a bt elm327 adaptor
is likely 9600 or 38400 baud.

Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.015 seconds.

  Follow me on twitter