Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Theme Issue

Pages: [1]
Author Topic: Theme Issue
Posts: 2917
Post Theme Issue
on: February 23, 2019 (GMT)

I am using Start/Stop angles with built-in
0110 and 010B pids. I have also created
custom pids which use the same pids but
different equations for modified scaling.
These custom pids do not use the Start/Stop
angles I defined.

It’s a problem since Torque assigns the same
addresses for both [10] and [0b]. (I need to
read the raw hex bytes so using [ ] and Val{ }
without using mode/pid won’t work).

I expected both built-in and custom pid to
use the same Start/Stop Angle_xx definition.

Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.027 seconds.

  Follow me on twitter