Forums

Guest
Welcome Guest, posting in this forum require registration. Username Password Remember me

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Torque pro to can bus

Pages: [1]

Author	Topic: Torque pro to can bus

5genhatch

Member
Posts: 1

Torque pro to can bus
on: October 26, 2018 (GMT)

All this stuff is kinda out of my experience level but here is what i tried to do. Car is a 90 skyline gtr with a haltech platinum ecu which has a can bus output. I got a obd2 connector from the junkyard and made a harness to go between my ecu and obd2 connector. I wired in ground/ignition/can hi/and can low. Connected a obd link mx which connected to my phone but did not talk to the ecu in the torque app. Is this even possible. I know the vehicle is not obd2 but you are able to pull data from the ecu through the can bus with a 0 digital dash. Any help is appreciated

moreause

Member
Posts: 632

Re: Torque pro to can bus
on: October 28, 2018 (GMT)

Can bus is just a type of communication

the can bus port is just there for there own device wide band /display

and i suspect that the univesel haltech doesn’t have the software to drive OBD2 thru that port

was working on my hyundai genesis … but mine was a plug an play version with some OBDII support

i would say go on the haltech forum for more info

Pages: [1]

WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.008 seconds.

Forums

Forums

Guest