Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Torque can't read codes on 2005 F250 Diesel???

Pages: [1]
Author Topic: Torque can't read codes on 2005 F250 Diesel???
agdodge4x4
Member
Posts: 1
Post Torque can't read codes on 2005 F250 Diesel???
on: August 3, 2018 (GMT)

I swear I have never had a problem before but I don’t read codes often.

ECU Problem

The ECU is reporting that it does not support the reading of any PIDs.
Your vehicle may not be OBD2 compliant OR the vehicle ECU has not been enabled by your dealer/manufacturer for OBD2 access.

Torque will probably not be able to retrieve information due to this problem

This pops up when trying to scan codes on the truck when engine off key on. It still seems to pull codes, but it does not give useful information. I don’t understand what this error means.
Capp777
Member
Posts: 2994
Post Re: Torque can
on: August 3, 2018 (GMT)

Its likely the command issued by Torque
to retrieve supported OBDII mode 01 pids is
not returning a successful response.

The supported list, if any, would be found
under the Adapter Status icon information
in Torque Pro.
jdferdon
Member
Posts: 1
Post Re: Torque can
on: August 7, 2018 (GMT)

FYI – 2005 F250 Diesel is less likely to be OBDII compliant. Most likely the ECU will give a negative response for lots of requests.

Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.012 seconds.

  Follow me on twitter