Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » Arduino Code

Pages: [1]
Author Topic: Arduino Code
LAN-Opfer
Member
Posts: 5
Post Arduino Code
on: July 28, 2018 (GMT)

I tried to usethe Arduino Code with a ESP32. With a few changes, it is running – but is does not connect to torque. It allway tries to find the protocol – any ideas about the problem?

Uwe
LAN-Opfer
Member
Posts: 5
Post Re: Arduino Code
on: July 28, 2018 (GMT)

Now I tried with the pro version: torque reports “Profil: nicht unterstützt” (Profile: not supported) :-(

Uwe
LAN-Opfer
Member
Posts: 5
Post Re: Arduino Code
on: July 29, 2018 (GMT)

It seems to be a problem with sensor definition. ESP32 sends

0,a,i,-,Pot 1,Potentiometer 1,v,0,5,
1,a,i,-,LDR 1,Light Sensor 1,v,0,5,
4,d,o,0,Dout1,Digital Out 1,bit,0,1
‘LF’
‘PROMPT’

and Torque answers with
ATPC
ATZ
ATE0
…

-> endless loop :-)

any help?

Uwe
LAN-Opfer
Member
Posts: 5
Post Re: Arduino Code
on: August 2, 2018 (GMT)

The communication runs after a few extensions in the code. But Torque do not send the command “GETDEFINITIONS” to get the sensor definition. Will I have to do some settings to force that command?
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.014 seconds.

  Follow me on twitter