Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » How choose Vacuum diplay to a Custom PID?

Pages: [1]
Author Topic: How choose Vacuum diplay to a Custom PID?
tinsfci
Member
Posts: 2
Post How choose Vacuum diplay to a Custom PID?
on: April 23, 2020 (GMT)

Greetings,
I´ve made a Custom PID that reads MAP from my TBI system.
Since manifold pressure often is below atmospheric pressure (except when full throttle or boost) I want to have the data displayed on an analog Vacuum Gauge. But I only seem to get a “regular” gauge, not the one with needle going counter-clockwise when pressing full throttle.

How can I add the “Vacuum Gauge”?
Do I need to re-write my Custom PID so that values gets “backward”?
moreause
Member
Posts: 643
Post Re: How choose Vacuum diplay to a Custom PID?
on: April 24, 2020 (GMT)

you can modify your pid
your pid minus atmospheric pressure
will give you negative value

they will be in the same unit as the boost value

i didn’t find a way to convert into mmHG or inHG in vacuum

https://www.youtube.com/watch?v=pfsUIwOmRTY
Capp777
Member
Posts: 2994
Post Re: How choose Vacuum diplay to a Custom PID?
on: April 24, 2020 (GMT)

Maybe this will help …

https://torque-bhp.com/forums/?wpforumaction=viewtopic&t=9644.0

https://torque-bhp.com/forums/?wpforumaction=viewtopic&t=14696.0
tinsfci
Member
Posts: 2
Post Re: How choose Vacuum diplay to a Custom PID?
on: April 24, 2020 (GMT)

Thanks,

I´ll check these and come back with results!
Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.014 seconds.

  Follow me on twitter