Torque

Forums

Forums

Guest  

Show or hide header
Welcome Guest, posting in this forum require registration.

Torque » Torque OBD ECU Scanner » Torque Discussion / Ideas » ECM commands from Torque?

Pages: [1]
Author Topic: ECM commands from Torque?
blistovmhz
Member
Posts: 6
Post ECM commands from Torque?
on: August 22, 2018 (GMT)

So I’ve got quite a bit of electronic control of my ECM via HPtuners. Being able to increase base idle on the fly is handy as hell, but HPT is way overkill for a permanent installation. I figure it’s all just serial data, so is there any way to snoop the bus to figure out what’s being sent for a given function (ie: increasing idle speed to 2000rpm while I run my air compressor) and send that command from Torque?
moreause
Member
Posts: 644
Post Re: ECM commands from Torque?
on: August 24, 2018 (GMT)

i would say no

hpt mostly rewrite the pcm itself

torque mostly read and ask for standard obd request

you can’t even do that with the device at the dealer

Pages: [1]
WP-Forum by: Fredrik Fahlstad, Version: 2.4
Page loaded in: 0.034 seconds.

  Follow me on twitter