Forums
Forums
Notifications
Clear all
Topic starter
Sorry if this is s stupid q
Is there a manual?
I ran it with header default, mode 01 start 00 end ff
It only found 33pids
What are the headers?
What are the ignores about?
Posted : 22/02/2022 12:43 pm
I've been wondering the same thing, was hoping there was some explanation on the different settings.
Have you had any more luck?
Posted : 23/02/2022 6:49 pm
Does your 33 match the sensors supported
under the Adapter Status icon information?
Just curious...
No manuals.
Headers are protocol specific so some advanced
understanding is needed. Same for OBD terminal.
Sending the wrong command(s) could have adverse
effects.
It might be nice to display the protocol used in
TorqueScan displays involving headers/commands.
Another Torque Pro user.
Posted : 23/02/2022 8:37 pm
Topic starter
It would also be nice if Torque Scan speed which pid of its currently wiring, so I've does not thick it is stuck
When it find PIDs it reports then as
PiD:01 nn
Is that 01 the mode?
Posted : 24/02/2022 10:18 am
Hi!
Yes 01 is the mode, I'll change that part of the display in the next update
Posted : 24/02/2022 12:04 pm
