Here is short summary regarding my issue:

PID: 22242C
Header: 7E0
Response: 7E8037F2211

I assume this response is wrong because when I try another PID I got exact same response from ECU.

When PID is 22242C response should looks like 62242CXXYY I guess.

Any suggestions what should cause this?
Is my OBD Header wrong?
Do I need to know ISO code?

Thanks

you must first issue a session initialization command 10C0, and then already issue your PID

I wrote it in Torque profile but the response is still the same.

perhaps you need to give a synchronization command 1003 instead of 10C0

https://disk.yandex.ru/i/IJLrmQZ7PB3cfA
https://disk.yandex.ru/i/SVAvd7slQjgivg
https://disk.yandex.ru/i/mfmrfjgUZJy_aw

Thank you for your support.

I have replicated everything from your 3 screenshots, unfortunately I can't connect to ECU with this init AT commands sequence.

When I try init AT commands sequence without ATSP6 line I can establish connection with ECU.

Howewher, PID is still responsing 7E8....in this case.

Is this caused because of missing ATSP6 command?

you need to check the adapter
issue commands from the initialization line in the terminal and post a screenshot of the adapter's responses

when you establish a connection with the ECU, look at the adapter status tab for which protocol the ECU connects
what year is your car?

I took some screenshots based on your request. Hope there is all you tell me to do.

https://ibb.co/nc0sJ4M
https://ibb.co/FxXsMdh
https://ibb.co/tY5Q8Nq
https://ibb.co/dbJ08sj
https://ibb.co/Fgbr2WX

Edit:
Car year is 2012.

https://disk.yandex.ru/i/gTRIrn672AZJTQ
https://disk.yandex.ru/i/v9MSEHPkiOHSoA
ATSP8
ATSH7E0
ATCRA7E8
1003 or 10C0