Hi, 

I don't know if is an issue introduced on version 1.12.106 (where most of dysplay types was bronke) or 1.12.108 that should have fixed.

Anyway, if I add a Display to monitorize the performance (eg. 0-100km/h or 80-120Km/h), instead to show "Ready" is shown "0,00"  and the performance option that need to be measure is not measured.

I found a workaround for this:

Set the display type from "Digital Display" to "Dial (Needle)", set the number of decimal places to "use display default"  and then change back the display type from"Dial (Needle)" to "Digital Display".

Doing that inside the display, is shown "Ready" and the choosen performance can be measured.