Forums
Forums
Notifications
Clear all
Torque main forum
6
Posts
3
Users
0
Reactions
973
Views
Topic starter
I have an 07 F150 and I use my Torque Pro as much as I possibly can. I have the Ford PIDs added ect. One thing I cant figure out is if I put the individual cylinder misfire counts on a dashboard they don't show any misfires. Does this setup only show at the moment of a misfire? If I run the test results it will show if there is a misfire but not on the counters on the dashboard. Am I doing something wrong?
Thanks!
Posted : 24/02/2017 5:41 pm
It may be those pids work on older Fords.
You may need to rely on the mode 6 TID 53?
and others.
Posted : 24/02/2017 6:28 pm
Topic starter
Dang that's what I use now but since the PCM was reset then I have to complete an OBD2 drive cycle to get it to read those. I don't know what it takes to complete them but it took quite a while last time. Thank you for the reply.
Posted : 24/02/2017 7:20 pm
I just -this morning - posted a response concerning this very issue that you might find helpful since the individual cylinder counts are not applicable to our trucks. http://www.f150forum.com/f4/5-4-rough-idle-372760/index2/#post5200962
Some other very good PID's that I have dug up that you might find interesting. They relate to a common problem with F150s having to do with Variable Cam Timing. I posted a lengthy description with formulas and dashboard examples here: http://www.f150forum.com/f4/final-repair-guide-5-4-cam-phaser-tick-knock-sound-141266/index304/#post5133357
Hope this helps you get more out of Torque Pro.
-----------
54371019
Posted : 24/02/2017 8:36 pm
Topic starter
Haha hey Torqued! This StephenG from the F150 forum LOL! I was just posting here hoping someone here might have some extra insight. I should have known you'd be a member here too! Thanks Fella!
Posted : 24/02/2017 9:25 pm
Glad to see ya guy. Best wishes.
Posted : 25/02/2017 12:13 am
