Forums
Forums
Notifications
Clear all
Topic starter
Hello fellow Torquers!
For some reason, when I add dials they are all on celsius and kph instead of fahrenheit and mph. Even the existing dials are c/kph. I tried with the check boxes check and unchecked. No matter what, they stay on c/kph. Anyone else have this issue? I am fully updated as well. Any help would be greatly appreciated! Thank you very much for your time in advance!
Robert
Posted : 22/07/2011 5:01 pm
This has been brought up a few times. What you need to have fresh data running to those dials first from the OBDII then they'll switch over to the desired units. To know if you have data running to them the little green light next to the text will blink green every time the data has been refreshed. Here is a link to another post about it.
http://torque-bhp.com/forums/?wpforumaction=viewtopic&t=962.0
Posted : 22/07/2011 6:11 pm
