Hello, it will work with your car. But it wont read your boost readings.
It's the same for vw/audi 1.8T.

Hi

Actually, as of 1.4.10(the latest version on the market), Boost is now supported, so it will work in all VW / Audi vehicles. Make sure you set your engine displacement correctly in the settings.

Regards,

Ian

woah, seriously? just tried mine and it reads 25psi at idle which sounds seriously off. ..

you may need to adjust for atmospheric pressure (subtract 14.7 psi at sea level) using the boost adjust option in the vehicle profile. Unfortunately it is a vehicle dependant thing.

So (assuming you are at sea level), you have about 10.3 psi boost which is around 0.7 bar boost.

Quote from admin on March 30, 2011
you may need to adjust for atmospheric pressure (subtract 14.7 psi at sea level) using the boost adjust option in the vehicle profile. Unfortunately it is a vehicle dependant thing.

So (assuming you are at sea level), you have about 10.3 psi boost which is around 0.7 bar boost.

thanks. when i took it out last night it was reading -20 or so at idle, and went up to about 0 on WOT. I'm roughly at sealevel here...

Hi Ian, I emailed you about this issue about 3 weeks ago as well. I have a Jetta 1.8t and I'm getting similar readings as the other guy even though I have adjusted the settings for sea level.

Hi, a couple of people have reported this so I'm getting information and I'll see if anything is out in the code (and fix it if it is)

If you want to help out with logfiles, then have a look at the thread here:

http://torque-bhp.com/forums/?wpforumaction=viewtopic&t=459.1

and send me the .csv file (with a note of what vehicle it's for), that would help a lot

Thanks

Ian